Services
Emergency
Language
Home/Services/Steam turbines
Steam turbines

Steam turbines opened, measured and set right.

Generator-drive and mechanical-drive steam turbines from any manufacturer: casing-off overhauls in the field, rotor and blading work in the shop, and re-rates that recover heat rate.

Shop & fieldRotorsBladingRe-rates

Steam turbine overhaul

Planned outages with casings open: inspection, clearances, alignment and every valve that controls the steam.

GESiemensElliottDresser-RandMitsubishiToshibaSkoda
  • Casing opening, inspection and clearances
  • Rotor removal, NDT and run-out survey
  • Stop, control and extraction valve overhaul
  • Bearings, oil deflectors and gland seals
  • Reassembly, alignment and restart support

Rotor repair

Rotors repaired, straightened and balanced in the shop, or replaced when the life assessment says so.

  • Weld repair and build-up of journals and seal areas
  • Rotor straightening
  • Journal grinding and polishing
  • Low-speed and high-speed balancing
  • Coupling and tenon repair
  • Replacement rotor manufacture

Blading & diaphragms

Erosion and fatigue take the steam path apart slowly. We restore it stage by stage.

  • Reblading and blade replacement
  • Stellite erosion shield replacement
  • Diaphragm repair and alignment
  • Nozzle block repair
  • Coatings against solid particle erosion

Re-rates & efficiency upgrades

Change megawatt output or recover lost heat rate when the steam conditions or the plant around the turbine have changed.

  • Steam path redesign for new conditions
  • Advanced seals: brush, abradable, retractable
  • Heat rate recovery programs
  • Life extension studies

Governing & auxiliaries

Most steam turbine trips start outside the casing.

  • Hydraulic to electro-hydraulic governor retrofits
  • Valve actuator overhaul
  • Lube and control oil systems
  • Gland steam and drain systems
  • Overspeed trip testing

Lifetime & root cause

Know what is left in the machine and why it failed, before deciding what to spend.

  • Remaining life assessment for creep and fatigue
  • Metallurgical replication and hardness surveys
  • Root cause analysis of failures
  • Condition reports for insurers and lenders
What you receive

Records at every decision point.

You approve the work from evidence, and you keep the evidence after the unit is back in service.

Before work

Findings report

Photo-documented teardown findings, measurements against limits and a repair disposition for every part.

Decision point

Priced scope

Line-item quote for repair, replace or exchange, with turnaround for each option, before work is released.

On handover

As-left dossier

Dimensions, clearances, coating and weld records, balance reports, test data and the next-interval plan.

Unit tripped · forced outage

A machine down is a clock running.

Call the emergency desk. An engineer takes the first diagnosis by phone, asks for trend data and borescope access, and mobilises a field crew when the problem cannot be cleared remotely.